Cable pusher BKS 800

Have you ever been faced with the task of pulling cable along meandering courses, through street under crossings or in narrow ducts? If so, you will know how soon the stress limit of the cable being pulled is reached and how soon you will have to fit a connection piece. In order to avoid premature cable cutting and fitting of connection pieces, it is advisable to use a Bagela Cable Pusher in front of a bend, which will reduce cable stress and allow longer cable lengths to be pulled.

Each use of the Cable Pusher BKS 800 will save the cost of fitting one connection piece. No extra time will be squandered for:

  • cutting the cable
  • moving the cable drum
  • excavating a connection pit
  • barring of the connection pit
  • refilling the connection pit


The cable passes over two pairs of tapered pulleys, which are driven by electric or hydraulic motor. Two counter pulleys press the cable into the grooves of the two driving pulleys, thus ensuring adequate friction. For effective power transmission the tapered driving pulleys are consisting of a special, highly elastic, tough and wear-resistant rubber material with a high coefficient of friction.

The gap between the tapered pulleys can be varied, so that cable and tubes of 30 to 180 mm in diameter and three single lead 20 kV cables in one strand can be pushed. After the cable has been laid in place, the press-on unit can be removed and the cable taken out and put aside. As the machine is extremely low (340 mm), there will be no unwanted bends in the cable after pushing. Owing to its compact design the cable pusher may be used in any cable trench or pit.

The cable pusher is driven by an electric motor. By means of appropriate power distributors, several cable pushers may be operated in parallel. Upon request, the cable pusher will be supplied with hydraulic motor to be connected to a hydraulic power pack or the hydraulic system of a mini-excavator.

Cable Pusher BKS 800 used for laying 110 kV cable in an industrial site. Where the passage is free, cable pulling may be continued by means of a cable-pulling winch, which draws the cable direct on to the cable holding shelves.

BKS 800 Kabelschubgerät



BHA 200/10

Hydraukilc power pack with petrol engine

Order No. 010.120.01

Hydraulic hoses
with speedadjustment, 5 m

Order No. 003.558.04

Technical Data


TypePush power
Drive EngineLength
Order No.
BKS 800 E 8 0-10 1,5 kW/
380 V
1300 450 650 168 012.002.00
BKS 800 H 8 0-10 - 1300 450 650 157 012.002.10
BHA 200/10 Hydr. Power Pack - - Petrol, 4kW 600 400 550 65 010.102.02
Hydraulic hoses with speed adjustment 5 m + 1,25 m - - 10,2 003.558.04
Hydraulic hoses without regulation 10 m - - 10,8 003.558.02
Control unit for Cable Pusher System for 5 BKS 800E         003.220.90V
Control unit for Cable Pusher System for 10 BKS 800E         003.220.91V

Type E: Elektric motor with mechanical gear
Type H: Hydraulic motor driven by hydraulic power pack

Painting Traffic red RAL

Specifications are subjects to change without notice

Go back